Taper Candle Dipping Frame Instructions
Dipping tapers is far more productive than molding them. Although the initial setup cost is somewhat higher, dipping can provide dozens of tapers per hour. Molding on the other hand will provide one candle per mold every one to two hours.
- Use thumb screws to set the height of the adjustable arms (align the arms) - note that for a 12" candle it will need to be set larger than 12" apart. Add Approximately 2".
- Tie the wick to a lower arm.
- Wind wick onto frame, going straight up, over one arm, straight down, over one arm, etc... keeping the slack out.
- When you reach the final arm tie off the wick while maintaining tension on it.
- Trim excess wick.
- Prepare all the frames in this manner.
- Make some type of hanging setup for the frames. This may be a suspended pipe, a board with hooks, etc. It is best to have some way to hang these after each dip.
- For best results use 6 to 12 frames.
- Hold one frame by hook, extend arm straight out. The bottom of the frame is the maximum height the top of your dipping vat should be positioned. Placing the vat higher will rapidly exhaust you.
- Dip the frames one at a time then hang. The first dip should be held in the wax until wick stops bubbling.
- By the time you dip the last frame, the first should be ready for its next dip.
- Repeat until the desired thickness is obtained.
- Allow to cool.
- Cut candles from frames. They may be left in pairs or cut apart.
- To remove excess wax on the frames heat the dipping vat to 190 degrees or so. Place the frames inside until the wax melts.
Support Free Projects
You can help ensure the continued availability and production of free candle making projects and instructions by telling your friends about them. The more popular they are the more we can produce so tell your friends, mention them on message boards, link to them from your web site, etc... More information is available here.
Disclaimer: The information presented here is accurate to the best of my knowledge and common candle making practices as of the time of this writing Originally published in January 2006 and updated July 2011. The author and the publisher accept no liability for the use or misuse of any of the information presented in this article. This article is presented for informational purposes and is used at your own risk.
Author: Bob Sherman
Publisher: Bobby's Craft Boutique Inc.
This article is provided free of charge for use. Candles may be made and sold using this design royalty free, however no portion of this article may be reproduced for publication elsewhere without express permission from Bobby's Craft Boutique Inc. with the following exceptions:
- Non profit organizations such as religious groups, scouts, 4h, etc... may use this information without permission for printed materials provided it is used without modification and credit is given to both the author and onestopcandle.com
- Reprinting to the web is prohibited without permission, however web sites wishing to link to this article may do so without permission.